Simplicity Serge Pro SW432 Bedienerhandbuch PDF herunterladen (Seite 40)

Turning Outside Corners

Turning Inside Corners

1. Stitch along one edge until you reach the corner. Take one

stitch off the edge of the fabric (fig. A). (As you approach

the edge, you may want to stop and manually turn the

handwheel towards you.)

2. Raise the needle(s) to the highest position.

3. Clear the stitch fingers, and rotate the fabric to reposition

the needle at the previous row of stitching (fig. B). Gently

pull up on all threads to remove slack and resume

stitching (fig. C).

Note: A loose thread loop at the corner is caused by too

much slack in the needle thread when clearing the stitch

fingers. T

ry again, turning corners takes a little practice!

1. Reinforce loosely woven fabrics at the corner with

staystitching on the conventional sewing machine. Clip to

the corner (fig. A).

2. Align the fabric edge with the blade, and stitch until the

blade reaches the corner, not the needles. Don't cut into

the corner (fig. B).

3. Lower the needle(s) to anchor the fabric.

4. Raise the presser foot and straighten out the fabric,

forming a pleat at the corner (fig. C).

5. Be sure the marked stitching line is straight, then continue

serging the remaining edge. When done correctly, the

pleat will disappear after stitching (fig. D).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Keine Kommentare

Simplicity Serge Pro SW432 Bedienerhandbuch Seite 40